When constructing with a rotary drilling rig, if the pick teeth suddenly get stuck, it may be because these details have not been paid attention to.

In the deep hole construction of pile foundations, carbide tooth jamming can disrupt the construction schedule, damage drilling tools, and even trigger safety hazards. This issue is mostly caused by the neglect of three construction details. This article breaks down these details to help avoid such risks.

Detail 1: Improper Selection of Carbide Teeth

Construction teams often continue to use old models or choose universal carbide teeth, ignoring the compatibility between the geological conditions and the teeth. For example:
  • Using soft-soil carbide teeth in weathered rock formations makes it easy to “fail to cut through” the rock.
  • Using hard-rock carbide teeth in clay layers leads to the problem of “drill bit balling” (clay adhering to the drill bit).
  • Mismatch between the number of teeth, their arrangement density, and the hole diameter or geological conditions also increases the risk of jamming.
Recommended Solutions: Conduct a geological survey before construction to select carbide teeth tailored to the specific conditions. Replace the teeth promptly when there are sudden changes in the geological structure.

Detail 2: Neglect of Carbide Tooth Wear

On-site personnel often make arbitrary judgments about the wear of carbide teeth. Specific risks of excessive wear include:
  • When the wear of the tooth head exceeds 1/3, the cutting force will decrease and friction will increase, leading to jamming.
  • Wear on the side of the teeth will damage concentricity.
  • Broken fragments of worn teeth can cause severe jamming.
Recommended Solutions: Establish a regular inspection system. Replace teeth immediately if their wear exceeds the standard or if there are cracks. Ensure uniform wear of all carbide teeth. Wear-resistant coatings can be applied to extend their service life.

Detail 3: Inadequate Attention to the Slag Discharge System

Poor slag discharge leads to the accumulation of debris at the bottom of the hole, forming a “slag cushion”. In this case, the carbide teeth will grind the debris first rather than cutting the rock formation, which accelerates tooth wear and easily causes jamming when the teeth are wrapped by debris.
Common causes of poor slag discharge include:
  • Insufficient mud concentration in sandy soil layers.
  • Inadequate air compressor pressure in hard rock formations.
  • Blockage of slag discharge pipes.
Recommended Solutions: Optimize the slag discharge plan according to the geological conditions. Clean the slag discharge pipes regularly and control the drilling speed properly.

Conclusion

Carbide tooth jamming in pile foundation construction is caused by inadequate control of details. By properly selecting carbide teeth in advance, replacing worn teeth in a timely manner, and ensuring smooth slag discharge, the risk of jamming can be significantly reduced, thereby guaranteeing the construction progress and safety.