Frequent Pick Drop-Offs? Don’t Overlook Coal Buildup in Holders, This Hidden Culprit

At underground fully mechanized mining faces, frequent pick shedding ranks among the most troublesome equipment maintenance headaches.

Many veteran fitters focus entirely on whether the circlip is properly seated and if the pick tip is correctly oriented during replacement, yet they nearly skip the most critical pre-installation step: clearing coal buildup inside the pick holder.

This seemingly trivial detail is actually the hidden culprit behind circlip failure and pick drop-off.

How Coal Buildup Causes Failures

❶ Disturbs fitting clearance → False tight locking Coal slurry and rock fragments trapped inside the holder bore occupy fitting space and prevent the pick from seating fully. Suspended in this way, the pick bears eccentric load during cutting. This accelerates wear on the holder bore wall and may even crack the holder in severe cases.

❷ Uneven loading on circlips → Sudden breakage An uneven holder bottom forces the circlip into twisted stress after installation. When hitting hard rock or impact loads during cutting, the circlip snaps instantly and loses its locking function for the pick.

❸ Pick rotation blocked → One-sided eccentric wear and premature failure The core advantage of conical picks is free rotation for even wear. Once wet coal compacts into hard lumps and jams the pick shank, rotation stops immediately. The carbide tip quickly chips on one side, and massive impact loads transfer straight to the circlip and holder, triggering pick detachment.

❹ Repeated shutdowns → Skyrocketing overall costs Installing picks without proper cleaning leads to premature failure and unplanned downtime. Frequent replacement wastes picks and damages costly holders, directly lifting the mining cost per ton of coal.

Standard 4-Site Operating Procedure

① Thorough cleaning with no residue Before fitting, use high-pressure water guns, air blowers or dedicated wire brushes to fully remove slurry, rust and debris inside the holder bore until bare metal is visible at the bottom.

② Trial fitting and rotation check After cleaning, place the new pick into the holder for a trial fit. Rotate it by hand to confirm smooth movement without jamming and normal clearance before proceeding.

③ Standard installation and circlip inspection Make sure the circlip fully seats into the groove with no deformation or cracks. Lightly tap the pick head with a hammer after installation and judge proper seating by sound.

④ Moderate lubrication (subject to working conditions) Once cleaning is completed, apply a proper amount of special grease inside the holder bore to lower friction resistance. Note: Grease type and dosage must strictly follow the shearer or roadheader OEM manual. Improper grease may attract coal dust and aggravate abrasive wear.

Closing Remarks

No maintenance task is too small; details dictate operational efficiency. Cleaning coal buildup from one holder takes barely two minutes, yet it can prevent downtime of half an hour or longer for pick replacement.

If you have encountered other tricky pick maintenance issues in daily work, feel free to share in the comments!