Many mining and tunneling sites set replacement criteria purely based on carbide tip wear, while ignoring a subtle annular groove on the pick body.
It may look like a simple wear mark, yet it signals abnormal fitting between the pick and pick holder. If you keep running it just because the pick “still rotates”, you will face costly breakdowns far beyond the price of a single pick once fracture occurs.
1. What Is This Annular Groove?
It is a continuous or intermittent circumferential indentation near the mating surface between the pick shank and pick holder. Unlike uniform normal wear on the carbide tip, this mark is visible to naked eyes.
To put it simply: it resembles the deep indentation left on an iron bar after being bound tightly with thin steel wire for a long time. It is not on the tip, but on the shank.

This groove proves the pick is swinging continuously and bearing irregular loads inside the holder.
2. Root Causes of Annular Grooves
① Worn pick holder with excessive clearance After long service, the inner wall of the holder wears and enlarges. The pick loses stable positioning and oscillates repeatedly during cutting. Recurring friction between pick and holder gradually carves out the annular groove.

② Improper pick installation The pick is not fully seated, or the retaining circlip fails. Under impact loads, persistent micro-rotation triggers localized friction and groove formation.
③ Heavy impact + abrasive dust Rock dust and grit squeeze into the clearance between pick and holder, creating abrasive wear that deepens the groove rapidly. This deterioration accelerates drastically in highly abrasive strata.
3. Hidden Risks Brought by Annular Grooves
Essentially, the groove reduces the effective wall thickness of the pick shank and weakens its load-bearing cross-section.
- Sharply increased risk of pick fracture The groove becomes a stress concentration point, prone to fatigue breakage.

2.Cascading component damage Broken pick fragments left in the working face may damage critical parts such as cutterheads and cutting drums, multiplying repair costs.
3.Unplanned downtime losses A single pick costs only a few hundred, but one unexpected shutdown can easily trigger losses worth thousands or more.
4. Practical Recommendations for Site Management
✅ Establish visual inspection standards for picks Add “annular groove on pick shank” to daily checklists. Mark and replace picks with obvious grooves in scheduled maintenance, instead of waiting for breakage.
✅ Inspect picks and holders as a matched set Check wear and deformation of the corresponding holder whenever replacing picks. If the holder clearance is out of tolerance, merely swapping picks will lead to recurring failures and higher consumption.

✅ Standardize assembly procedures Make sure retaining circlips are correctly fitted, control fitting clearance, and avoid premature abnormal wear caused by poor installation.
✅ Increase inspection frequency for abrasive strata Picks fail faster under high-dust, high-impact conditions. Shorten inspection cycles to forecast replacement timing in advance.
Quantitative reference: When the groove depth reaches 1/3 of the pick shank wall thickness, or the visible groove width exceeds 5 mm, the fracture risk rises exponentially. Immediate replacement is recommended.
Summary
The annular groove is not ordinary wear; it is an early warning of mismatched fit between pick and holder. For project management, regular visual inspection and proactive replacement are far more cost-effective than emergency breakdown repairs.
Disclaimer: Recommendations above are generalized for common working conditions. Final replacement criteria shall comply with OEM manuals and actual geological conditions on site.