Recently, MilinMate Series 35 roadheader cutting picks have successfully completed on-site testing under specific working conditions—the test was conducted in an F10-F12 high-hardness rock tunnel with a 2.1*2.5m cross-section. The entire test proceeded without any abnormal faults, and all 50 cutting picks completed their full wear cycle. Calculations show the following results:
- Total Operation Length: 5.8 meters
- Unit Wear Rate: 1.5 picks per cubic meter on average
- Compliance Result: Surpassed the client’s requirement of ≤2 picks per cubic meter and passed the test in one attempt.

Highlight Analysis: Newly Designed “Self-Sharpening” Cutting Picks
During the test, the self-sharpening function of the Series 35 shrinkage-type cutting picks emerged as the core advantage of great interest to the client. Unlike traditional picks that tend to blunt after wear and suffer reduced rock-breaking efficiency, MilinMate shrinkage-type picks are enhanced by two key design features:
- Self-Sharpening & Tip Self-Restoration: As the picks rotate with the drill head, they wear evenly and automatically restore to a sharp tip shape without any additional intervention, maintaining high-efficiency rock-breaking performance at all times. The shrinkage-type structure further strengthens this self-restoration effect while improving rock-breaking penetration.
- Lightweight & Malfunction Prevention: The shrinkage-type tooth body design reduces the weight of the picks, directly lowering the pressure exerted on the snap rings. This fundamentally minimizes common faults such as “pick slipping” and “snap ring breakage”, enhancing operational safety and continuity.

Optimization Direction: Adding Wear-Resistant Coating for Extended Service Life
Some areas for optimization were identified during the test: the edge of the 80-disk is prone to wear as it is not welded with a wear-resistant coating.
To address this issue, MilinMate has clearly defined the follow-up optimization direction—applying a wear-resistant coating to the edge. It is estimated that after wearing down to the safety line, the picks can withstand an additional 10mm of wear, further extending their service life.

Future Plan: Expanding Shrinkage-Type Design to Multiple Pick Specifications
Building on the outstanding performance of the Series 35 shrinkage-type picks, MilinMate plans to fully promote this design: the shrinkage-type structure will be extended to a wide range of pick models in the future. This will allow the advantages of “self-sharpening” and “lightweight malfunction prevention” to cover more working conditions, providing clients with more efficient and durable cutting pick solutions.
Working conditions serve as the ultimate benchmark for testing product quality. Guided by customer needs at all times, MilinMate continuously optimizes product design through real-world working condition tests. The successful testing of the Series 35 picks once again validates the feasibility and advantages of the shrinkage-type design. Going forward, we will continue to focus on product refinement and create cutting pick solutions that are more tailored to on-site operational needs.
