Straight column alloy, the “fixing needle” for hard rock excavation – solving the dilemma of tunnel boring machine construction loss

In the hard rock excavation of mine tunnels, frequent wear, chipping, and broken handles of picks are one of the common pain points in construction.

Every time a tooth is replaced, the machine is shut down for half an hour; several times a day, the construction schedule lags and the cost soars.

Data shows: Under hard rock working conditions, the maintenance cost of the cutting head accounts for more than 30% of the maintenance cost of the entire machine, and pick failure is the main cause of operation interruption.

No matter how powerful the equipment is, if the selection of picks does not match the working conditions, it will not be able to chew through hard rock.

Three major pain points in hard rock working conditions

① Frequent wear and tooth replacement becomes the norm

High-hardness minerals such as quartz and feldspar continue to wear the cutter head. Ordinary picks will be worn out in hard rock in a day or two. The single cost is not high, but the long-term consumption is huge.

② Broken teeth and broken handles, causing chain damage

The impact load of hard rock is large, and the toughness of ordinary picks is insufficient, and the teeth are easy to chip and the handles are broken. Fracture residue will also damage the roller and gear seat, increasing maintenance time and costs.

③ Frequent shutdowns and delays in construction

If the pick fails, the machine must be shut down and replaced. High-frequency interruptions disrupt construction plans and are the most difficult problems for project management to solve.

Why are straight alloy picks recommended?

A large amount of research and field practice have confirmed that straight column alloy picks are an effective solution to solve the loss dilemma of hard rock excavation.

Compared with traditional conical and mushroom-shaped alloy heads – the cross-sectional area continues to shrink after wear, the impact force gradually increases, and the more it is worn, the weaker it becomes;

During the wear process of the straight column alloy, the cross-sectional area is stable, the stress is distributed evenly, and there is no sudden increase in stress. With a 60° chamfer structure, it can bear higher impact and is highly adaptable to synchronous wear of hard rock.

Measured data:

Alloy head shedding rate: 43% → 13%

Tooth breaking rate: 23% → 11%

Core advantages: stable force, strong impact resistance, firm welding fit, and long service life.

(Actual results vary depending on rock formation conditions, equipment parameters and operating specifications)

Vacuum welding seams are dense

Hard core technology: comprehensive upgrade of materials and processes

High-strength tooth body: 35CrMnSi base material, quenched and tempered, hardness 40–45HRC, impact toughness ≥49J/cm², both tough and tough.

Special cemented carbide: low-cobalt, ultra-coarse-grained tungsten carbide formula, hardness HRA87.7–88.3, ​​wear-resistant and shatter-resistant.

Vacuum brazing + heat treatment: metallurgical grade combination, eliminates false welding and cracks, reduces residual stress, and is capable of high-frequency impact.

Practical verification: better than ordinary picks

A large number of actual measurements in tunnels and mines have shown that the wear resistance of straight column alloy picks is far superior to that of ordinary picks, significantly reducing tooth chipping and handle breakage, and significantly reducing the frequency of shutdowns for tooth replacement.

The overall excavation efficiency is increased by more than 30%, effectively reducing comprehensive costs such as consumables, maintenance, and construction delays.

construction site
Wear status of straight cylindrical picks

Conclusion: Choose the right pick to reduce downtime anxiety

For working conditions such as granite, limestone, and gangue-incorporated hard rock, straight-column alloy picks have stable cutting performance, low loss, and long service life, and are the preferred solution for hard rock excavation.

Reduce downtime for gear replacement, improve construction efficiency, and reduce overall costs from the source – making the construction period more controllable.