Three “invisible pitfalls” in installing cutting picks that most people tend to step into

If certain key steps are overlooked during the installation of cutting picks, it will not only accelerate the wear of the picks but also may lead to equipment failures, a sharp drop in construction efficiency, and even safety accidents. These hidden dangers are often “cumulative”—they are easy to ignore in the early stages but may cause serious consequences later on.

Ignoring the “gap check”

Is the “gap check” often skipped?
  • Excessive gap: When the cutting pick is drilling, it will produce “radial shaking”. The cutter head collides repeatedly with the edge of the tooth holder, which intensifies the wear of the tooth holder and may even cause it to deform or crack. At the same time, it leads to uneven force on the cutting pick, making the cutter head prone to chipping, and its average service life will be shortened by more than 40%.
  • Insufficient gap: The cutting pick cannot rotate flexibly (normal rotation requires slight movement to ensure uniform wear), which will cause “uneven wear” — one side of the cutter head is quickly worn flat, while the other side is almost unworn. This in turn leads to a sudden increase in drilling resistance and excessive load on the equipment motor, which may cause motor burnout or hydraulic system failure.

Omitting “torque verification”

Is bolt tightening done by feel?
  • Bolts too loose: During drilling, the cutting picks are prone to falling off due to vibration. The high-speed rotating drilling tools may fling off the detached picks, endangering the safety of personnel nearby. Meanwhile, the tooth holder at the 脱落部位 will directly rub against the stratum, causing the tooth holder to overheat and deform, with extremely high repair costs.
  • Bolts too tight: This will lead to stress concentration on the bolts, which are prone to fracture under continuous impact, also possibly resulting in the falling off of cutting picks. In addition, over-tightened bolts may squeeze the pick body, causing it to crack.

Neglecting the “installation angle”

Is angle calibration considered a hassle?
  • Angle deviation: The cutting pick fails to cut the formation according to the designed trajectory. It either “bites too deep into the soil” resulting in excessive resistance, or “cuts too shallow” leading to low efficiency. At the same time, it will cause some cutting picks to bear additional lateral force, resulting in “abnormal breakage”.
  • Inconsistent angles: The cutting picks on the same drill bit are subject to uneven force. Some cutting picks wear quickly due to excessive load, forming a “vicious circle” — after the severely worn cutting picks fail, the load on other cutting picks further increases, eventually causing the entire set of cutting picks to be scrapped in advance and even damaging the drill bit itself.

These overlooked steps may seem trivial, but they directly affect the stress state of the cutting picks, the uniformity of their wear, and the safety of the equipment. Especially in the construction of hard rock and complex formations, negligence in installation details can reduce the service life of the cutting picks by more than half.